PSA Nitrogen Generator – JOOZEO Carbon Molecular Sieve

When producing nitrogen, it is important to know and understand the purity level you needed. Some applications require low purity levels (between 90 and 99%), such as tire inflation and fire prevention, while others, such as applications in the food ang beverage industry or plastic molding, require high levels (from 97 to 99.999%). In these cases PSA technology is the ideal and easiest way to go.

In essence a nitrogen generator works by separating nitrogen molecules from the oxygen molecules within the compressed air. Pressure Swing Adsorption does this by trapping oxygen from the compressed air stream using adsorption. Adsorption takes place when molecules bind themselves to an adsorbent, in this case the oxygen molecules attach to a carbon molecular sieve (CMS). This happens in two separate pressure vessels, each filled with a CMS, that switch between the separation process and the regeneration process. For the time being, let us call them tower A and tower B.

For starters,clean and dry compressed air enters tower A and since oxygen molecules are smaller than nitrogen molecules, they will enter the pores of the carbon sieve. Nitrogen molecules on the other hand cannot fit into the pores so they will bypass the Jiuzhou carbon molecular sieve. As a result, you end up with nitrogen of desired purity. This phase is called the adsorption or separation phase.

It does not stop there however. Most of the nitrogen produced in tower A exits the system (ready for direct use or storage), while a small portion of the generated nitrogen is flown into tower B in the opposite direction (from top to bottom). This flow is required to push out the oxygen that was captured in the previous adsorption phase of tower B. By releasing the pressure in tower B, the carbon molecular sieves lose their ability to hold the oxygen molecules. They will detach from the sieves and get carried away through the exhaust by the small nitrogen flow coming from tower A. By doing that the system makes room for new oxygen molecules to attach to the sieves in a next adsorption phase. We call this process of ‘cleaning’ an oxygen saturated tower regeneration.